i.e. using a Black or Translucent Arkansas from bevel set through to finish...
I assume this'll work just fine tbh; if you kick up an atoma slurry on a trans ark it's a seriously fast stone, and it'll get progressively finer as you work and dilute the slurry, while simultaneously burnishing the surface, until finishing clean, or even with oil... et voila! Simple.
Anyone done it? Success? Thoughts?
I'm gonna give a go later anyway. Probably use the HB6 below, rather than the HB8.
I assume this'll work just fine tbh; if you kick up an atoma slurry on a trans ark it's a seriously fast stone, and it'll get progressively finer as you work and dilute the slurry, while simultaneously burnishing the surface, until finishing clean, or even with oil... et voila! Simple.
Anyone done it? Success? Thoughts?
I'm gonna give a go later anyway. Probably use the HB6 below, rather than the HB8.