Hey guys,
So I bought a Slim and a Gilette Super Speed. Both are in fully working condition.
So I take the SS and insert a blade and twist to tighten the head, and what I notice is that the twisting handle blocks a bit when the blade is still in a perfectly flat position, but I then can twist it again with more strength until the blade really bends at an angle and cannot twist anymore. I noticed the same thing with the Slim but to a lesser degree.
My question is: Should I stop the twist when the blade is completely secure in the head but still in a flat position, or do I continue twisting pushing the center of the blade towards the head's ceiling and thus giving the outer blade edges an angle?
I am confused. Thanks.
.
So I bought a Slim and a Gilette Super Speed. Both are in fully working condition.
So I take the SS and insert a blade and twist to tighten the head, and what I notice is that the twisting handle blocks a bit when the blade is still in a perfectly flat position, but I then can twist it again with more strength until the blade really bends at an angle and cannot twist anymore. I noticed the same thing with the Slim but to a lesser degree.
My question is: Should I stop the twist when the blade is completely secure in the head but still in a flat position, or do I continue twisting pushing the center of the blade towards the head's ceiling and thus giving the outer blade edges an angle?
I am confused. Thanks.
.
Last edited: