So the clip on my Franklin- Christoph cap sprung out a bit, which kind of sucked because of the way the cap is glued on
while trying to press down on the clip something felt, different then it should have is the best way i could describe it, so i twisted the cap and sure enough
the caps are not glued at all but threaded on, and the clip is held with a simple Phillips screw. and when threading back in, being sure not to over torque
the logo lined back up perfectly
thought it was a near tip to share with you guys
while trying to press down on the clip something felt, different then it should have is the best way i could describe it, so i twisted the cap and sure enough
the caps are not glued at all but threaded on, and the clip is held with a simple Phillips screw. and when threading back in, being sure not to over torque
the logo lined back up perfectly
thought it was a near tip to share with you guys