This was just a practice run. Not going to put them on a blade beside just to see how they work plus I git to build the wedge still but here it is. The picture don't show the sine as well as the naked eye but a CA finish but only 6 coats. I might go ahead and pin them on a blade so I can practice that too. They are 1/8 inch thick at this time. I was afraid they were going to be too thin.
I was thinking I'd put more layers of CA on but now that they are buffed with rubbing compound I'm afraid it wouldn't mix with the next layers of CA. Anyone agree with this or think its ok? Not bad for a first try if I say so myself!
Now I know what I'm up against so its time to buy some nice wood for this project and give it my all.
I was thinking I'd put more layers of CA on but now that they are buffed with rubbing compound I'm afraid it wouldn't mix with the next layers of CA. Anyone agree with this or think its ok? Not bad for a first try if I say so myself!
Now I know what I'm up against so its time to buy some nice wood for this project and give it my all.
Last edited: