A short restoration tutorial...
Nov 21, 2014 Thread starter #4 Mike H Instagram Famous Cover the ferrule with tape and drill out with a small, and then a large drill bit Last edited: Nov 21, 2014
Nov 21, 2014 Thread starter #6 Mike H Instagram Famous Clean out with dremel sanding drums Last edited: Nov 21, 2014
Nov 21, 2014 Thread starter #7 Mike H Instagram Famous Sand and polish the ferrule Last edited: Nov 21, 2014
Nov 21, 2014 Thread starter #9 Mike H Instagram Famous Set ferrule and new knot using epoxy Last edited: Nov 21, 2014
Nov 21, 2014 Thread starter #13 Mike H Instagram Famous FL shaver said: Nice! Pretty small opening, eh? Where did you source the knot? Click to expand... The opening was 22mm, I ordered a 20mm boar from The Golden Nib.
FL shaver said: Nice! Pretty small opening, eh? Where did you source the knot? Click to expand... The opening was 22mm, I ordered a 20mm boar from The Golden Nib.
Nov 22, 2014 #16 FL shaver Mike H said: The opening was 22mm, I ordered a 20mm boar from The Golden Nib. Click to expand... Beautiful job!
Mike H said: The opening was 22mm, I ordered a 20mm boar from The Golden Nib. Click to expand... Beautiful job!
Sep 19, 2018 Thread starter #18 Mike H Instagram Famous After 4 years, this is my favorite brush. I reach for it 90% of the time.
Sep 19, 2018 #19 aboulton1989 Awesome thread! And fun to see the longevity of the brush and favor with it. Rubberset made beautiful brushes, happy to see one still cared for so well. Sent from my SM-N900V using Tapatalk
Awesome thread! And fun to see the longevity of the brush and favor with it. Rubberset made beautiful brushes, happy to see one still cared for so well. Sent from my SM-N900V using Tapatalk