- Thread starter
- #21
Any updates on your mod, Mick?
I had the Hottop all apart then ran low on coffee so had to put it all back together to keep roasting as my parts did not show up with the disassemble timing
My probes and panel mount plugs came in on Saturday but my PO is only open M-F so I did not get my hands on them until today.
I stuck the mount in my pocket with the intent on getting a nut for it that I can silver solder onto the back panel so I can screw the mount in and out, thus replacing it with a small bolt should I decide to go back to "stock" .....BUT..... I forgot to go to the hardware store when I was out today
I decided to go with open tip automotive EGT sensors. A tad more expensive but faster responding (or so it says they are). I did get a couple inexpensive k type probes and will put one of them inside with the control electronics to monitor how hot the boards get to see if I need a slow turning fan in there to move more air.
NO telling when I will get out with the car again as I never drive anywhere anymore. With everything within walking distance I have pretty much given up driving except for doctor visits and such.
Last edited: