Getting ready to try restoring an Ever-Ready C40 What size knot?
For any of you that have restored this particular model before, which knot size did you use? Thinking about going Super Badger on this one. Also, where do you veteran brush restorers get Flitz and black epoxy?
For black epoxy, I add two drops of Testors model car paint (Gloss Black) to the epoxy as I mix it. Works fine. I've done three with no problems at all.
I buy my flitz online. I haven't found it at any stores. But I haven't looked recently either.
I've never done a C40, but I imagine it's a 20mm. I'd get it out before ordering a new one.
Post #13 of this thread shows a 20mm knot for the C40
The handle looks just like a 150 which also takes a 20mm knot.
Here is another thread with the same brush:
Last edited by otto76; 08-12-2011 at 02:27 PM.
Reason: added detail
I woulda worn my tuxedo but my Polo pony ate it!!!
Good luck with your project.
By PeteG1027 in forum Brush Making and Restorations
Last Post: 06-10-2011, 11:15 PM
By AdamBomb in forum Shaving Brushes
Last Post: 11-16-2010, 08:46 AM
By braxis in forum Shaving Brushes
Last Post: 10-18-2010, 04:08 AM
By pezdaddy in forum Shaving Brushes
Last Post: 01-05-2010, 11:18 AM
By fidjit in forum Shaving Brushes
Last Post: 11-09-2009, 04:54 AM
By accessing Badger & Blade, you agree to abide by the