What to put on this brush's handle

[Hex]

I use this brush a lot and it gets pretty wet and soapy. I caught it a few times after it slipped out of my hand but I would rather prevent it falling to the floor.

I have seen rubber bands suggested for razor handles but nothing for brushes.

Any ideas ?

A great brush btw Loric and thanks again.

[inspiringK]

Maybe try rubbing your alum block against the handle every so often. I just have no idea if it may harm the handle (doubt it though).

[RGraphics]

Try some skateboard grip tape or glue some water resistant sandpaper.

[Mike'sWorld]

Rubber O-rings would work. Available in any hardware store in any size.

This would look stylish too, if that is a concern of yours.

[M80]

maybe this?

[btuer60]

Rubber O-rings would work. Available in any hardware store in any size.

This would look stylish too, if that is a concern of yours.

+1 :thumbup1:

[maxman]

Would a little bit of heat shrink tubing work?
I don't think the heat would be enough to harm the handle, but you'd want to keep it away from the hair.